================================================================
Relay Click Demo
================================================================

Overview
----------------------------------------------------------------
This demo shows how to use the Relay click.  MPLAB(R) Code 
Configurator(MCC) is used to configure the processor, pins, and 
peripherals.


Hardware Configuration
----------------------------------------------------------------
1) Plug the Relay Click into the correct mikroBUS(tm).
2) Refer to the hardware.txt file attached to the project for 
   more information about any processor specific limitations or
   configuration required.

This demo uses the following mikroBUS pins:
* CS
* PWM

For more information about the bus mapping for this specific
processor, please refer to the hardware.txt file packaged with 
this example.


Running the Demo
----------------------------------------------------------------
Two buttons on demo board will control the two relays.  Each
will close the relay when pressed and open the relay when 
released.  Refer to the button_mapping.h file to determine which 
buttons is used for each relay for the board/processor you are 
using.


References/Links
----------------------------------------------------------------
[1] http://www.mikroe.com/click/relay/
[2] http://www.microchip.com/mplab/mplab-code-configurator

Legal
----------------------------------------------------------------
mikroBUS(tm) a trademark of MikroElectronika.
MPLAB(R) is a registered trademark of Microchip Technology Inc.